Aircommand IBIS ROOFTOP CARAVAN Instrukcje Operacyjne Pobierz pdf (Strona 11)

Set temperature a few degrees below room temperature. Note: The digital readout =

actual room temp. Press down or up arrow the readout will blink out the set point and

then return to room temp.

The fan will start immediately and the compressor will start after a 3 minute delay.

Check unit runs OK and cools.

OPERATING INSTRUCTIONS

Turn the unit on by pressing the ON /OFF button once

Press the MODE button to cycle through options Cool, Dry, Heat , and Fan.

To select cooling, cycle mode button to highlight COOL.

You may select either High, Med, Low, or Auto fan speeds by pressing the FAN

button. It is recommended that you choose Auto.

Now select the desired room temperature (herein refereed to as SETPOINT).

By pressing the TEMP up or down keys, the readout will flash the setpoint

temperature. Keep pressing the button until it flashes your desired setpoint.

In approx 5 seconds the display will resume reading the actual roomtemp.

The compressor will have a delayed start usually 3 minutes, before unit starts to cool.

NB: Any interruption to the power supply will cause the unit to delay compressor start

up.

For simply recirculating air, choose the FAN mode.

Choose any of the three fan speeds by pressing FAN button.

NB: Temperature button is invalid in Fan only mode.

To heat, press MODE button to highlight HEAT.

Select desired setpoint temperature by pressing TEMP buttons up or down.

It is recommended that AUTO fan speed be selected.

1 2 ... 6 7 8 9 10 11 12 13

Brak uwag

Aircommand IBIS ROOFTOP CARAVAN Instrukcje Operacyjne Strona 11